since a while, my creator prints no exact anymore. it goes like this:
it starts printing a circle at, let's say, 6 o'clock , starts moving outside the radius at 1.30 to 1,
continues with the old radius until quite exact the opposite position, moves again a little
bit outside, continues and so meets the first point again.
looks funny with square, see the pdf
No matter which slicer und which sofware, what I get is an ugly egg instaed of a baeutiful disk.
I tightened the x- and z-axis belts (because that needed my felix when it did the same) and now
I'm stuck in the middle of nowhere.
does anybody have an idea?
Maybe the x or y axis is not correctly lubricated, or do they have some dirty?
Try to move the carriage manually: do you find any point in which the carriage does not run freely?
Check if the bearings are good / clean. And check if the x - y axis are straight (not bending).
... no more ideas on this matter.