Leapfrog Support Team Document - http://support.lpfrg.com

| Applies To Leapfrog Creatr Series Single, Dual, HS, & XL:
| This solution explains how to correct printed 
output that appears shifted along X or Y axes.

------------------------------------------------------------------------------------------------------------------------------------------------

If your prints come out shifted or staggered along X axis direction or Y axis direction a possible solution is to tighten the black grub/set screws that hold the pulleys tight on the shaft that protrudes from the motors.


Follow the steps below to properly check if the grub/set screws are loose:




X direction(left-right)


1. Press X Home button inside the software.

2. Check for lost motion by pushing the printing carriage with your hand, like you see in the videos below:


Loose grub screws for X motor




Tight grub screws for X motor




Y direction(front-back)


1. Press Y Home button inside the software.

2. Check for lost motion by pushing on the X rails with your hand, like you can see in the videos below:


Loose grub screws for Y motor




Tight grub screws for Y motor




If you find that the grub screws need to be tighten you will need a 2 mm Allen key to do the job.