Hello and thank you for choosing the Leapfrog  Creatr for your printing needs.


The solution applies to the: Lepfrog Creatr Single and Dual extruder and also the Creatr XL.


To adjust the tension on the Y and X belts on your Leapfrog Creatr 3D printer you need to follow the steps presented below:

1. First how to adjust the tension in the X belt: using a number 3 Allen key, loosen the two bolts holding the belt on the printhead frame and move the belt inward to put more pressure or outward to loosen it if it is to tight;

2. Now adjusting the Y belt: using a number 5 Allen key loosen the bolts holding the stepper motor bracket in place and push the motor closer to the back of the printer to increase the tension on the belt, or pull it towards the front to put less pressure on the belt;

Now make sure to double check the bolts you loosened and make sure they are tight and you can start printing again.

 Thank you for reading the solution and, for any other issues, please do not hesitate to contact our Leapfrog Support Team.


We wish you happy printing!