Hello and thank you for choosing the Leapfrog Xeed for your printing needs.

 

The following solution will instruct you on how to solve the issue regarding the print head not stopping properly when the Level Bed command is used.


- First of all we would like to assure you that there is nothing wrong with the printer mechanically.


- All you will have to do in order to solve this issue is to reboot the printer and make sure that the right hot end is selected before you run the calibrate bed command.


- If for example the left one is selected this issue might appear when the bed is calibrating as the offset for the print head will shift a bit more to the right than normal.


- So please make sure the right hot end is selected and note that our R&D department will solve this issue with the next firmware release for the Xeed printer.


We thank you for checking out our Leapfrog 3D Printer technical support solutions online! If you were unable to fine a solution in our database, please feel free to open a new support ticket by clicking the following link: I want to open a new support ticket.