Hello and thank you for choosing the Leapfrog Xeed for your printing needs.

The following solution will instruct you on how to test the level of you Xeed print bed.

Once you have used the bed level command and adjusted the Z offset for your Xeed, a good way to test the level of the bed is to actually run the attached gcode and see what the results are.

Please make sure that before you run the gcode you put a print sticker on the surface of the bed so that the layers will stick to the bed. If you do not use a print sticker on the bed the filament will not stick to the bed and curl up on the nozzle.

Finally the attached gcode is for PLA extrusion on the right hot end, so please make sure to load the proper type of filament.

We thank you for checking out our Leapfrog 3D Printer technical support solutions online! If you were unable to fine a solution in our database, please feel free to open a new support ticket by clicking the following link: I want to open a new support ticket.