Hello and thank you for choosing the Leapfrog Xeed for your printing needs.

Before starting to install the software you need to download it. Please see the link below:


Next follow the steps below:

1) Download Win32DiskImager

2) Install Win32DiskImager

3) Input empty USB disk bigger than 4GB

4) Start Win32DiskImager

5) Select the usb disk on the right under “Device”. *Make a 100% sure you select the correct USB device! The program will remove all data from selected device! We are not responsible for any data loss.*

6) Select the image file, (make sure to show all files *.* and not just *.img because our files are a .bin)

7) Press Write, accept the warning that it might corrupt the disk.

8) When done input USB disk into Xeed and press either F7/F8/F12 depending on the machine in the Xeed to select the USB for start up.

Please note there is also a instructional video you can follow by clicking the link below:


We thank you for checking out our Leapfrog 3D Printer technical support solutions online! If you were unable to fine a solution in our database, please feel free to open a new support ticket by clicking the following link: I want to open a new support ticket.