Maintenance

Mechanical & Electrical solutions focusing on the Leapfrog Creatr HS 3D Printer

Calibrating the print bed on the Creatr HS (XL)
Hello and thank you for choosing the Creatr HS for your printing needs. In the following solution we will show you how to calibrate the heated bed for y...
Wed, 11 Mar, 2020 at 8:57 AM
Cleaning the print bed
Hello and thank you for choosing the Creatr HS for your printing needs. The solution applies for the Creatr HS, Creatr HS Lite, Creatr HS XL; ...
Tue, 10 Mar, 2020 at 11:13 AM
Cleaning the extruders
Hello and thank you for choosing the Creatr HS for your printing needs. The following solution will instruct you on how to properly clean your Creatr HS...
Tue, 10 Mar, 2020 at 11:14 AM
Calibrating the hot ends
Hello and thank you for choosing the Creatr HS / HS XL for your printing needs. The following solution will instruct you on how to align your Creatr HS ...
Tue, 10 Mar, 2020 at 11:16 AM
Calibrating offset between extruders on the Creatr HS (XL)
Thank you for choosing the CreatrHS for your printing needs. In the following solution you will be instructed on how to set the extruder offset for your...
Wed, 11 Mar, 2020 at 8:55 AM
Unclog hot end
Hello and thank you for choosing the Creatr HS for your printing needs. The solution applies to the Creatr HS, Creatr HS lite and Creatr HS XL. The fol...
Tue, 10 Mar, 2020 at 11:38 AM
Replacing the hot end
Hello and thank you for choosing the Creatr HS for your printing needs. In the following solutions you will be instructed on how to replace your Cre...
Tue, 10 Mar, 2020 at 11:40 AM
How to Calibrate the Offset for Your Creatr HS Hot Ends
Hello and thank you for choosing the Creatr HS for your printing needs.   In the following solution you will be instructed on how to calibrate the off...
Thu, 24 Mar, 2016 at 3:22 PM
How to Clean the Drive Units of My Creatr HS 3D Printer
  Hello and thank you for choosing the Creatr HS for your printing needs.      The following solution will instruct you on how to clean the drive of t...
Wed, 9 Mar, 2016 at 9:32 AM
Creatr HS (XL) - Hot end assembly
This solution article will explain how to assemble the Leapfrog Creatr HS (XL) hot end.  Required tools and parts Tools Size Allen key 1...
Mon, 8 Nov, 2021 at 12:26 PM