Repair Instructions

Update Machine Firmware (Motor Control Board) Bolt Pro
!!Warning uploading the wrong firmware will damage the machine. Please pay close attention that you select the Bolt_firmware for the Bolt and The correct Bo...
Wed, 11 Mar, 2020 at 8:47 AM
Update Machine Software (User Interface)
Compatible with:  Leapfrog Bolt  Leapfrog Bolt PRO Leapfrog Xcel Description:  Please find attached the instructions on how to Manually "Flash&...
Tue, 3 Mar, 2020 at 12:35 PM
Replacement: Printhead Internal Tubing
This solution article will describe how both inner printhead tubes can be replaced on a Leapfrog Bolt PRO  Tools:  The needed tools for this maintenanc...
Mon, 10 Feb, 2020 at 12:11 PM
Replacement: Printhead PCB
In the attachment you will find the document how to replace the head pcb's on the Bolt. 20171027_Leapfrog_Work_Instruction_Head_PCB_Replacement_v2....
Thu, 6 Feb, 2020 at 9:26 PM
Replacement: Printhead Cable Chain
Please follow the attached instructions to replace the ethernet cables.
Thu, 6 Feb, 2020 at 9:18 PM
Replacement: X-motor
To replace the motors you will need the following tools: Wrench 10 mm allen key 2 allen key 2.5 1. Please disconnect the printer from the power...
Thu, 6 Feb, 2020 at 9:23 PM
Replacement: E-Motor (Printhead Extrusion)
This article will show you how to replace a printhead drive unit stepper motor Step 1 - Disconnect the wire harness of the stepper motor marked in gree...
Thu, 20 Feb, 2020 at 10:31 AM
Replacement: Z-motor
In the attachment you will find the document that describes how to replace the Z-motor.
Tue, 11 Feb, 2020 at 10:29 AM
Replacement: Z-spindle
Please follow the attached instructions for spindle(s) replacement.
Tue, 11 Feb, 2020 at 10:21 AM
Replacement: X-motor/endstop Cables
This solution article will describe how both X-motor/endstop Cables can be replaced. Tools and Parts: The needed tools and parts for this maintenance a...
Fri, 14 Feb, 2020 at 4:32 PM