Repair Instructions

Firmware archive Creatr (XL)
In case you are looking for an earlier firmware version for your Leapfrog Creatr HS, then please find the files attached to this solution article.
Wed, 11 Mar, 2020 at 8:49 AM
Firmware: how to upload to Creatr (XL)?
Download the Correct Firmware Please see solution article for getting the correct firmware: Which Firmware Version do I Need for My Creatr Printer?...
Wed, 11 Mar, 2020 at 8:49 AM
Firmware: which version do I need for my Creatr (XL)?
Find out which firmware your machine needs by following these steps: 1) Does your Creatr have a black drag chain that guides the wires from the printing...
Wed, 11 Mar, 2020 at 8:50 AM
Firmware: which motorcontrolboard does my Creatr (XL) have?
Every Leapfrog Creatr is equipped with a motorcontrolboard. In total there is two different types and the Leapfrog Creatr can only be equipped with one of t...
Wed, 11 Mar, 2020 at 8:55 AM
How to Replace the Y-Axis Stepper Motor
Leapfrog Support Team Document - http://support.lpfrg.com | Applies To Leapfrog Creatr Series; Single, Dual & XL: | This solution instructs you how...
Mon, 4 Apr, 2016 at 1:12 PM
Why is my printing head moving in one direction only?
If the printing head moves in only one direction when you use the Y and/or X jog cotrols you need to check the following:          In this situation ...
Tue, 12 Jan, 2016 at 5:30 PM
How to replace the motherboard on your Leapfrog Creatr 3D printer.
Hello and thank you for choosing the Leapfrog Creatr for your 3D printing needs. This solution applies to the Creatr Single / Dual & Creatr XL; ...
Mon, 4 Apr, 2016 at 1:12 PM
Common mistake with replaced motherboard on the Creatr (XL)
"Why is my printer not working after I have replaced the motherboard?" In most cases when there is a requirement to replace the motherboard there...
Wed, 11 Mar, 2020 at 8:53 AM
How to Check the Function of the X and Y Stepper Motors on My Leapfrog Creatr 3D Printer
Hello and thank you for choosing the Leapfrog Creatr for your 3D printing needs. This solution applies to the Creatr Single / Dual & Creatr XL; ...
Wed, 23 Mar, 2016 at 10:28 AM
Adjusting the Z-endstop
Hello and thank you for choosing the Leapfrog Creatr for your 3D printing needs. This solution applies to the Creatr Single / Dual & Creatr XL; ...
Tue, 10 Mar, 2020 at 12:22 PM