Hello and thank you for choosing the Creatr HS for your printing needs.

If you encounter problems with the Z movement of the print bed you have to check the following:


-a number 13 wrench;

-a number 6 Allen key;

-a number 2 Allen key.

    First check the tension of the belt that transmits movement to the three Z rods and adjust the tension by unbolting the Z-axis belt tension assembly (indicated with the number 2 in the picture below) you can see in the picture below. You will need a number 13 wrench and a number 6 Allen key.

    The second option is to check the grub screws at the bottom of the pulleys(indicated with the number 1 in the picture above) and tighten them to avoid the belt slipping on the pulley thus no movement being transmitted to the assembly. To tighten the grub screws you will need a number 2 Allen key.

Thank you for reading the solution and for any other issues please do not hesitate to contact our Leapfrog Support Team.


We wish you happy printing!