Hello and thank you for choosing the Creatr Dual for your printing needs.
In the following solution you will be instructed on how to replace the heated bed on your Leapfrog Creatr Dual 2014
Unbolting the heated bed:
The first step is to turn the printer off and remove the side panels of the printer. Then using a number 8 wrench remove the 4 nuts holding the heated bed in place while holding the bolt in place using a number 4 Allen key;
Remove the interior cover plate to expose the electronic board:
To expose the electronic board the interior coverplate must be removed;
Disconnecting the wires from the heated bed:
Now disconnect the heated bed wires and remove the coiled protection cable all the way to the interior cover plate and disconnecting the thermistor from the motherboard; (Just the thermistor)
Now you can remove the heated bed and replace it with the new one by following these steps in reverse order from the bottom to the top.
Once the new bed is in place turn the printer on and make sure the heated bed is fuctional and if everything checks out calibrate the bed and start printing:
When connecting the wires of the new heated bed make sure the connectors are pushed all the way trough so as to avoid any unwanted contact between them that may result in a short circuit.
This part can be purchased from our website in the replacement parts section. Please note each printer model has it`s own section:
Thank you for reading the solution and for any other issues please do not hesitate to contact our Leapfrog Support Team.
We wish you happy printing!