Repair Instructions

Software solutions focusing on the Leapfrog Creatr HS 3D Printer and Simplify3D

How to Check the Functionality of the X and Y Stepper Motors - Creatr HS Series
Hello and thank you for choosing the Leapfrog Creatr HS series printer for your 3D printing needs.   This solution applies to the Creatr HS, Creatr H...
Wed, 6 Apr, 2016 at 12:29 PM
How to Replace the Ribbon Cable Sub Assembly
Hello and thank you for choosing the Creatr HS for your printing needs.   In the following solution we will show you how to replace the Ribbon cable...
Tue, 8 Nov, 2016 at 8:06 AM
How to Replace the PCB of Your Creatr HS Printer
Hello and thank you for choosing the Creatr HS for your printing needs.   The following solution will instruct you on how to change your Creatr HS PCB...
Wed, 9 Mar, 2016 at 9:17 AM
How to check the function of the limiter switches on the Creatr HS/ HS XL/ HS Lite.
Hello and thank you for choosing the Leapfrog 3D for your printing needs.   The steps below explain how to check the function of the limiter switches ...
Tue, 8 Mar, 2016 at 8:54 AM
Creatr HS Series: Under Extrusion - Explained
Technical Support receives a lot of tickets saying that the "printer is not working" or " the printer is causing...
Wed, 6 Jul, 2016 at 1:41 PM
Why is My Creatr HS Printing in the Air After a Few Layers?
Hello and thank you for choosing the Creatr HS for your printing needs. When you notice that your HS is printing in the air please make sure you che...
Thu, 7 Apr, 2016 at 9:15 AM
How to Replace the Filament Drive Units on the Creatr HS
   Hello and thank you for choosing the Creatr HS for your printing needs.        The following solution will instruct you on how to change the filam...
Thu, 24 Mar, 2016 at 12:48 PM
Creatr HS Series - Over Extrusion - Explained
We hardly get cases of over extrusion these days, but Technical Support loves providing information. So we decided to write this quick solution article in...
Wed, 6 Jul, 2016 at 2:56 PM
How to Install the Filament Drive Unit Cooling Fans
This solution link is provided for those who have ordered cooling fans for their Creatr HS filament drive units. Prior to being able to do these steps...
Mon, 4 Apr, 2016 at 1:10 PM
How to Replace the Z-Stop Induction Sensor on the Creatr HS Series
This solution link was created to help guide you through the replacement of the Z-Stop induction senor. Let's get started! NOTE: Not completing thi...
Thu, 22 Oct, 2015 at 2:48 PM