Maintenance

Specific knowledge & solution articles concerning 3d printing filaments.

Unclog the hot ends
Hello and thank you for choosing the Creatr Dual for your printing needs. The following solution will instruct you on how to unclog your Leapfrog Cr...
Tue, 10 Mar, 2020 at 12:19 PM
Calibrating hot ends
Leapfrog Support Team Document - http://support.lpfrg.com | Applies To Leapfrog Creatr Series Dual & XL:  | This solution instructs you ...
Tue, 10 Mar, 2020 at 12:20 PM
Calibrating offset between hot ends on the Creatr (XL)
Hello and thank you for choosing the Creatr for your printing needs.   In the following solution you will be instructed on how to calibrate the offset...
Wed, 11 Mar, 2020 at 8:51 AM
Calibrating print bed
Applies To Leapfrog Creatr Series; Single, Dual, and XL STEP 01: Make sure you have aligned both nozzles before moving forward with bed leveling...
Tue, 10 Mar, 2020 at 12:20 PM
Adjusting belt tension
Hello and thank you for choosing the Leapfrog  Creatr for your printing needs.   The solution applies to the: Lepfrog Creatr Single and Dual extruder ...
Tue, 10 Mar, 2020 at 12:21 PM
Replacement hot ends
Applies to the Creatr Single, Dual, XL Printers This solution has steps to replacing/removing the Creatr Hot End (Extruder and Heat Cartridge) (It ...
Tue, 10 Mar, 2020 at 12:21 PM
Creatr (XL) - Hot end assembly
This solution article will explain how to assemble the Leapfrog Creatr (XL) hot end.  Required tools and parts Tools Size Allen key 1.5 Al...
Mon, 8 Nov, 2021 at 12:28 PM