Maintenance
This solution article will describe how the bed and both printheads can be calibrated manually on a Leapfrog Bolt and Leapfrog Bolt PRO. Leapfrog Step 1...
Tue, 11 Feb, 2020 at 9:26 AM
Please find the following document available for download below: V1.5 Bolt (PRO), 20180619, Maintenance Schedule.pdf
Thu, 6 Feb, 2020 at 8:39 PM
If you are experiencing a clogged extruder during a print job and need help, then please have a look at this solution article. This article will focus on th...
Thu, 6 May, 2021 at 9:42 PM
Please follow the attached instructions to - Assemble - Install - Hot Tighten the E3D V6 Hot Ends on a Leapfrog Bolt PRO.
Mon, 10 Feb, 2020 at 12:16 PM
This solution article will explain when and how to replace the BuildTak Surface. This is surface is part of the magnetic Flexplate system available on Leapf...
Mon, 13 Jul, 2020 at 11:40 AM
Please follow the attached instructions if you are experiencing a clogged hot end.
Fri, 21 Feb, 2020 at 3:45 PM
In the attachment you will find the document that describes how to calibrate the wiper blades. The wiper blades are responsible for removing filament that i...
Tue, 11 Feb, 2020 at 10:52 AM
Achieving a good adhesion on the print bed is beneficial for the print quality of each print. If the distance between the nozzle and print bed is too big, t...
Tue, 3 Mar, 2020 at 9:11 AM
In the attachment you will find the document that describes how to clean the extruder drive gear. The extruder drive gear is in direct contact with your fil...
Tue, 20 Oct, 2020 at 9:44 PM
This solution article will describe how to perform the Calibration Print Test for Leapfrog Bolt (PRO). This Print Test can be used as a tool to determine / ...
Fri, 14 Aug, 2020 at 5:13 PM